Max Fill % variable needed
There needs to be a user-adjustable maximum fill ratio when filtering loads. This site appears to filter out all loads that approach or go over 100% fill ratio. Errors in the site's powder bulk densities can erroneously filter out known good loads, handicapping certain powders below max. pressure because the calculator thinks the case is full. H4350 appears to be an example: I have many known good loads in 7mm-08 and 300WSM that are within all book load limits that either get filtered out or are severely handicapped due to 100% fill ratio on this site, when in reality they are not compressed loads.
167 Views
I think I fixed it, cleared all browsing data and it seems to be good now.