Load data for 6 x 70 R + .243 | 90gr | CutEdge MTAC

6 x 70 R cartridge drawing
Cutting Edge logo

Load Specifications

Bullet Manufacturer:Cutting Edge
Bullet Weight:90 gr
Bullet Diameter:0.243"
Bullet Length:<<locked>>
Case Length (l3):2.75"
Cartridge Length (C.O.L.):<<locked>>
Case Capacity:39.9 Grains of Water
Primer Size:Large Rifle (LR)
Barrel Length:25.6"
Max. allowed Pressure:37,710 psi
Recommended Twist Rate:1:8.0

Load data in caliber 6 x 70 R with .243 | 90gr | CutEdge MTAC bullet and 12 powders. The key underlying parameters are shown in the table above. The recommended powders for this cartridge and bullet combination are ReloadSwiss RS 14 and Hodgdon TrailBoss.

Important Notice: DO NOT go below Minimum Charge or above Maximum Charge. Since we have no control over the equipment and components used, any responsibility and liability for the results achieved is rejected.

Only powders/loads that match the current filter criteria are displayed: max pressure of a load ≤ 90% of max. standardized pressure, fill rate ≥ 80% and propellant combustion ≥ 95%. Use the sliders above the tables to adjust these thresholds.

Charge: Powder weight in grains. Start with the minimum load and work up carefully.

FR (Fill Rate): Case fill as a percentage. Values above 100% mean compressed loads.

MaxP / %: Maximum chamber pressure in bar and as a percentage of the standardized maximum for this caliber.

V(0): Muzzle velocity in feet per second (fps) at the standardized barrel length.

z (Powder Burn): Estimated propellant combustion percentage at bullet exit.

A valid access license is required to use the Personalized Load Calculator.

You can find more information in our FAQ: How can I use the Personalized Load Calculator?

Max Load - Barrel Length: 25.6"

PowderChargeFRMaxP%V(0)z
Accurate 2495<<locked>>86%33,678 psi89%2526 fps99.8%
Accurate 4064<<locked>>88%33,953 psi90%2552 fps98.3%
Hodgdon TrailBossᴾ<<locked>>100%33,504 psi89%1726 fps100%
IMR 3031<<locked>>82%33,272 psi88%2552 fps99.2%
Lovex D073.6<<locked>>82%32,198 psi85%2500 fps96.6%
Norma 202<<locked>>82%33,663 psi89%2507 fps97.8%
ReloadSwiss RS 14ᴾ<<locked>>100%33,562 psi89%1768 fps100%
Shooters World Match Rifle<<locked>>82%32,198 psi85%2500 fps96.6%
SNPE Vectan Tubal 5000<<locked>>86%32,938 psi87%2425 fps98.4%
Vihtavuori N135<<locked>>84%32,445 psi86%2487 fps99.5%
Vihtavuori N140<<locked>>84%33,765 psi90%2490 fps98.1%
Vihtavuori N540<<locked>>84%32,677 psi87%2477 fps97.3%

Recommended = one of the top powders for this cartridge and bullet combination.

Start Load - Barrel Length: 25.6"

PowderChargeFRMaxP%V(0)z
Accurate 2495<<locked>>80%27,369 psi73%2375 fps98.5%
Accurate 4064<<locked>>80%25,918 psi69%2346 fps95.4%
Hodgdon TrailBoss8.3 gr80%24,613 psi65%1542 fps100%
IMR 3031<<locked>>80%31,053 psi82%2500 fps98.7%
Lovex D073.6<<locked>>80%29,747 psi79%2438 fps95.7%
Norma 202<<locked>>80%31,517 psi84%2454 fps97.1%
ReloadSwiss RS 148.5 gr80%24,772 psi66%1581 fps100%
Shooters World Match Rifle<<locked>>80%29,747 psi79%2438 fps95.7%
SNPE Vectan Tubal 5000<<locked>>80%26,963 psi72%2277 fps96.4%
Vihtavuori N135<<locked>>80%28,239 psi75%2385 fps98.6%
Vihtavuori N140<<locked>>80%29,617 psi79%2388 fps96.8%
Vihtavuori N540<<locked>>80%28,413 psi75%2369 fps95.7%

Recommended = one of the top powders for this cartridge and bullet combination.

ᴾ possible press load - work up slowly to this load while watching for signs of excessive pressure.

<<locked>> you need an access license to unlock this data.

This overview compares 12 powders for 6 x 70 R loaded with the .243 | 90gr | CutEdge MTAC. Accurate 4064 delivers the highest muzzle velocity at 2,552 fps; across all powders the maximum-charge window runs from 1,726 fps to 2,552 fps. Hodgdon TrailBoss gives the best case fill at 100 %, and 12 of the 12 powders fall inside the usable 80–100 % fill window.

Relative to the caliber's maximum pressure (260 MPa), the top charges use 85–90 %, leaving at least 10 % headroom. The 90.0 gr projectile in 0.243" calls for a 1:8.0 twist; slower twists will usually not stabilise this weight. Hodgdon TrailBoss, ReloadSwiss RS 14 reach 100 % fill or more at maximum charge, so these are compressed loads: they need a long drop tube to seat cleanly and react sensitively to the case capacity of your own brass lot. ReloadSwiss RS 14, Hodgdon TrailBoss rank at the top here: for 6 x 70 R with the .243 | 90gr | CutEdge MTAC they combine a high case fill with complete burn and sit in the upper velocity band. Always begin at the start load and work up in small increments while checking case and primer for pressure signs.

← All load data