Load data for .350 Mag. Rigby + .355 | 84gr | Inceptor RNP

.350 Mag. Rigby cartridge drawing
Inceptor logo

Load Specifications

Bullet Manufacturer:Inceptor
Bullet Weight:84 gr
Bullet Diameter:0.355"
Bullet Length:<<locked>>
Case Length (l3):2.75"
Cartridge Length (C.O.L.):<<locked>>
Case Capacity:91.1 Grains of Water
Primer Size:Large Rifle Magnum (LRM)
Barrel Length:24"
Max. allowed Pressure:44,962 psi

Load data in caliber .350 Mag. Rigby with .355 | 84gr | Inceptor RNP bullet and 8 powders. The key underlying parameters are shown in the table above. The recommended powders for this cartridge and bullet combination are ADI AR 2207, Vihtavuori N120 and ReloadSwiss RS 14.

Important Notice: DO NOT go below Minimum Charge or above Maximum Charge. Since we have no control over the equipment and components used, any responsibility and liability for the results achieved is rejected.

Only powders/loads that match the current filter criteria are displayed: max pressure of a load ≤ 90% of max. standardized pressure, fill rate ≥ 80% and propellant combustion ≥ 95%. Use the sliders above the tables to adjust these thresholds.

Charge: Powder weight in grains. Start with the minimum load and work up carefully.

FR (Fill Rate): Case fill as a percentage. Values above 100% mean compressed loads.

MaxP / %: Maximum chamber pressure in bar and as a percentage of the standardized maximum for this caliber.

V(0): Muzzle velocity in feet per second (fps) at the standardized barrel length.

z (Powder Burn): Estimated propellant combustion percentage at bullet exit.

A valid access license is required to use the Personalized Load Calculator.

You can find more information in our FAQ: How can I use the Personalized Load Calculator?

Max Load - Barrel Length: 24"

PowderChargeFRMaxP%V(0)z
ADI AR 2207<<locked>>92%40,480 psi90%3793 fps98.3%
Hodgdon TrailBossᴾ<<locked>>100%28,674 psi64%2579 fps100%
IMR 4227<<locked>>84%39,407 psi88%3671 fps96.7%
Lovex S053<<locked>>86%40,509 psi90%3704 fps99.4%
ReloadSwiss RS 14ᴾ<<locked>>100%28,065 psi62%2631 fps100%
ReloadSwiss RS 36<<locked>>84%38,406 psi85%3675 fps96.2%
SNPE Vectan BA6 1/2<<locked>>88%39,465 psi88%3543 fps100%
Vihtavuori N120<<locked>>90%38,087 psi85%3688 fps98.7%

Recommended = one of the top powders for this cartridge and bullet combination.

Start Load - Barrel Length: 24"

PowderChargeFRMaxP%V(0)z
ADI AR 220759.5 gr84%30,864 psi69%3504 fps95.1%
Hodgdon TrailBoss<<locked>>80%20,697 psi46%2320 fps100%
IMR 4227<<locked>>80%34,563 psi77%3527 fps95%
Lovex S053<<locked>>80%33,518 psi75%3507 fps98%
ReloadSwiss RS 1420.8 gr80%20,218 psi45%2365 fps100%
ReloadSwiss RS 36<<locked>>82%36,042 psi80%3606 fps95.4%
SNPE Vectan BA6 1/2<<locked>>80%31,415 psi70%3343 fps100%
Vihtavuori N12058.1 gr82%29,196 psi65%3412 fps95.8%

Recommended = one of the top powders for this cartridge and bullet combination.

ᴾ possible press load - work up slowly to this load while watching for signs of excessive pressure.

<<locked>> you need an access license to unlock this data.

This overview compares 8 powders for .350 Mag. Rigby loaded with the .355 | 84gr | Inceptor RNP. ADI AR 2207 delivers the highest muzzle velocity at 3,793 fps; across all powders the maximum-charge window runs from 2,579 fps to 3,793 fps. Hodgdon TrailBoss gives the best case fill at 100 %, and 8 of the 8 powders fall inside the usable 80–100 % fill window.

Relative to the caliber's maximum pressure (310 MPa), the top charges use 62–90 %, leaving at least 10 % headroom. Hodgdon TrailBoss, ReloadSwiss RS 14 reach 100 % fill or more at maximum charge, so these are compressed loads: they need a long drop tube to seat cleanly and react sensitively to the case capacity of your own brass lot. ADI AR 2207, Vihtavuori N120, ReloadSwiss RS 14 rank at the top here: for .350 Mag. Rigby with the .355 | 84gr | Inceptor RNP they combine a high case fill with complete burn and sit in the upper velocity band. Always begin at the start load and work up in small increments while checking case and primer for pressure signs.

← All load data