Load data for .30-30 Ackley Improved + .308 | 130gr | CutEdge ESP Raptor

Recommended Powder(s): Alliant AR-Comp, Alliant Reloder-10x, IMR 4198, Norma 200, Vihtavuori N130

Load Specifications

(Use the Personalized Load Calculator below to adjust )

Bullet:	.308 \| 130gr \| CutEdge ESP Raptor
Manufacturer SKU:	ESP C130 RAPTOR WoT
Bullet Weight:	130gr \| 8.4g
Bullet Diameter:	0.308" \| 7.82mm
Bullet Length:	<<locked>>
Caliber:	.30-30 Ackley Improved load data
Case Length (l3):	2.030" \| 51.6mm
Cartridge Length (C.O.L.):	<<locked>>
Seated Depth:	<<locked>>
Shank Seated Depth:	<<locked>>
Case Capacity:	48.6 Grains of Water \| 3.16 cm³
Primer Size:	Large Rifle (LR)
Max. allowed Pressure:	46412 psi \| 3200 bar
LID:	LID_B8471_C326
Last updated:	2026-02-11

Load data for 72 loads in caliber .30-30 Ackley Improved with .308 | 130gr | CutEdge ESP Raptor bullet and 36 powders such as Alliant AR-Comp, Alliant Reloder-10x, IMR 4198, Norma 200, Vihtavuori N130. The key underlying parameters are shown in the table above.

Important Notice: DO NOT go below Minimum Charge or above Maximum Charge unless there are reasons. Since xxlreloading.com has no control over the equipment and components used by the customer and the data used in connection with the website, any responsibility and liability for the results achieved is rejected. Also see our Terms of Service.

Questions regarding the load data: Please read the information in the next tab "Explanations".
A load must fulfill certain criteria to be listed in the default view below - see "powder criteria to fulfill to be listed".

Our load data might deviate from other sources - see the "most common reasons for deviations".

All loads are based on the bullet and case dimensions shown under "Load Specifications" - see "reloading suggestions" if you deviate.

You can set your specifications in the "Personalized Load Calculator".

Go to the bottom of the "Dashboard " page to set the measure system (imperial vs. metric)
No data yet
C.O.L. (Inch)
C.O.L. (mm)
We recommend you limit powder range to relevant brands to speed up re-calculation of results
Use the Personalized Load Calculator to customize loads to your own specific requirements. Find more details in the help section.

Our default view only displays powders/loads that fulfill certain criteria: Max pressure of a load <=90% of Max. Standardized Pressure. Fill Rate (Min FR): >80% and <100% for rife loads, >60% and <100% for pistol loads. Min. Propellant Combustion (Min z): >90% for rifle loads , >80% for pistol/revolver loads. Relax these criteria at your own risk to potentially get more powders shown in the load tables.
Case Length (Inch)
Case Length (mm)
CaseCapacity (GoW)
Min z (%)
Min FR (%)
Max FR*
Barrel Length (Inch)
Barrel Length (cm)
Safety Buffer (%)
.

Click on the desired row in the tables below to add a specific load / powder to your Diary and manage there.

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AR 2207	<<locked>>	88%	40683	88%	**97	100%
ADI AR 2219	<<locked>>	91%	41408	89%	**36	97%
Accurate 2015	<<locked>>	97%	40321	87%	**97	98%
[Accurate 2460]*	<<locked>>	95%	40524	87%	**90	93%
Accurate 2495	<<locked>>	96%	30618	66%	**02	96%
[Accurate 2520]*	<<locked>>	97%	34780	75%	**38	92%
Alliant AR-Comp 👍	<<locked>>	97%	35578	77%	**77	99%
Alliant Reloder-10x 👍	<<locked>>	94%	40959	88%	**26	99%
Alliant Reloder-7	<<locked>>	87%	41147	89%	**64	99%
Baschieri & Pellagri 106	<<locked>>	90%	40930	88%	**21	97%
[Hodgdon Benchmark]*	<<locked>>	96%	41655	90%	**61	93%
[Hodgdon CFE BLK]*	<<locked>>	86%	40770	88%	**98	92%
Hodgdon H322	<<locked>>	96%	40277	87%	**13	96%
Hodgdon H335	<<locked>>	92%	41582	90%	**33	95%
Hodgdon H4198	<<locked>>	87%	40814	88%	**15	96%
[IMR 3031]*	<<locked>>	96%	30197	65%	**46	93%
IMR 4198 👍	<<locked>>	92%	41336	89%	**80	100%
[Lovex D073.4]*	<<locked>>	94%	41640	90%	**93	93%
[Lovex D073.5]*	<<locked>>	96%	41046	88%	**00	93%
Norma 200 👍	<<locked>>	90%	41191	89%	**13	99%
[Norma 202]*	<<locked>>	96%	33982	73%	**92	93%
[ReloadSwiss RS 40]*	<<locked>>	95%	41379	89%	**07	94%
[Rottweil R 901]*	<<locked>>	97%	37594	81%	**38	94%
SNPE Vectan BA6 1/2	<<locked>>	84%	40640	88%	**70	100%
SNPE Vectan SP 10	<<locked>>	91%	40756	88%	**20	95%
[SNPE Vectan Tubal 3000]*	<<locked>>	97%	38537	83%	**92	94%
[SNPE Vectan Tubal 5000]*	<<locked>>	97%	30951	67%	**44	92%
[Somchem S321]*	<<locked>>	97%	41437	89%	**26	93%
Somchem S335	<<locked>>	96%	36158	78%	**75	95%
Vihtavuori N120	<<locked>>	90%	40669	88%	**51	100%
Vihtavuori N130 👍	<<locked>>	96%	41553	90%	**70	99%
Vihtavuori N133	<<locked>>	96%	34171	74%	**43	96%
[Vihtavuori N140]*	<<locked>>	96%	31966	69%	**20	92%
[Vihtavuori N530]*	<<locked>>	97%	41234	89%	**07	92%
[Vihtavuori N540]*	<<locked>>	97%	32300	70%	**46	92%
[Winchester 748]*	<<locked>>	97%	40886	88%	**30	93%

Max Load - Barrel Length: 23.60''

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AR 2207	<<locked>>	81%	32924	71%	**52	100%
[ADI AR 2219]*	<<locked>>	81%	29225	63%	**70	92%
[Accurate 2015]*	<<locked>>	81%	24062	52%	**36	92%
[Accurate 2460]*	<<locked>>	89%	32837	71%	**43	90%
[Accurate 2495]*	<<locked>>	87%	21263	46%	**49	90%
[Accurate 2520]*	<<locked>>	94%	30966	67%	**52	90%
[Alliant AR-Comp]*	<<locked>>	81%	21770	47%	**93	92%
Alliant Reloder-10x	<<locked>>	81%	26861	58%	**24	95%
Alliant Reloder-7	<<locked>>	81%	34621	75%	**43	98%
[Baschieri & Pellagri 106]*	<<locked>>	81%	30400	65%	**15	93%
[Hodgdon Benchmark]*	<<locked>>	91%	35085	76%	**33	90%
[Hodgdon CFE BLK]*	<<locked>>	84%	37492	81%	**39	90%
[Hodgdon H322]*	<<locked>>	84%	26861	58%	**05	90%
[Hodgdon H335]*	<<locked>>	82%	29776	64%	**83	90%
[Hodgdon H4198]*	<<locked>>	81%	33402	72%	**70	93%
[IMR 3031]*	<<locked>>	92%	26208	56%	**38	91%
IMR 4198	<<locked>>	81%	30008	65%	**51	97%
[Lovex D073.4]*	<<locked>>	88%	33808	73%	**52	90%
[Lovex D073.5]*	<<locked>>	90%	33286	72%	**56	90%
Norma 200	<<locked>>	81%	30472	66%	**06	97%
[Norma 202]*	<<locked>>	91%	28616	62%	**67	90%
[ReloadSwiss RS 40]*	<<locked>>	87%	32039	69%	**20	90%
[Rottweil R 901]*	<<locked>>	88%	29022	63%	**51	90%
SNPE Vectan BA6 1/2	<<locked>>	81%	37362	80%	**21	100%
[SNPE Vectan SP 10]*	<<locked>>	81%	29080	63%	**70	90%
[SNPE Vectan Tubal 3000]*	<<locked>>	89%	29472	63%	**05	90%
[SNPE Vectan Tubal 5000]*	<<locked>>	92%	26832	58%	**39	90%
[Somchem S321]*	<<locked>>	93%	35984	78%	**21	90%
[Somchem S335]*	<<locked>>	87%	26368	57%	**56	90%
Vihtavuori N120	<<locked>>	81%	30966	67%	**74	100%
[Vihtavuori N130]*	<<locked>>	81%	26049	56%	**46	94%
[Vihtavuori N133]*	<<locked>>	83%	22989	50%	**54	90%
[Vihtavuori N140]*	<<locked>>	93%	28558	62%	**34	90%
[Vihtavuori N530]*	<<locked>>	93%	36709	79%	**25	90%
[Vihtavuori N540]*	<<locked>>	94%	29617	64%	**83	90%
[Winchester 748]*	<<locked>>	93%	35404	76%	**15	90%

Start Load - Barrel Length: 23.60''

Any powder missing? Then click here.

FR ... fill rate of the cartridge in percent

MaxP ... max. pressure of load in psi or bar

% ... max. pressure of load in percent of the maximum allowed pressure for this caliber

V(0) ... muzzle velocity in feet per second (fps) or meters per second (m/s)

z ... powder burnt in percent

[...] *... not dangerous but load has suboptimal powder burnt with possible characteristics such as extensive muzzle flash or inaccurate loads.

[...] ²... fill rate low - you might want to consider using a filler to ensure proper ignition.

[...] ᴾ... possible press load - work up slowly to this load while watching for signs of excessive pressure.

👍 ... recommended powder/load for this caliber and bullet combination based on its ballistic performance.

<<locked>>... you need to buy an access license to unlock the data