top of page
XXL Reloading Discussion Group / Forum

XXL Discussion Group

Public·109 members
rawskrawsk
rawsk

Barrel length bug

ree

Max allowed is 30 cm when adding a new weapon.


Bugs
30 Views
kasper.vognbyggerkasper.vognbygger
kasper.vognbygger

Barrel length vs muzzle velocity

This is a bad implemented section. In my 338 loads, the statement is that every inch of added barrel adds approx 7,8 fps. while the graph show bnetween 20 and 35 fps added. Maybe there is a conversion to m/s going or what do i know. And there is no option to shift the graph to fit some numbers from the load data table, Not really usable.

Bugs
226 Views
Max
Max
Jul 29, 2025
•

ok - we found and fixed the bug. Thanks for flagging it! Much appreciated!👍

cptxaggiecptxaggie
cptxaggie

Norma Load Data wrong in graph

Go to Load Data by Bullet/Powder>Select Norma in Powder Section> See below powders, there is a graphic that shows "Norma Powders used by our Community..."> the legend for the powders listed shows Reload Swiss powders not Norma.

ree

Bugs
195 Views
Max
Max
Jul 09, 2025
•

Strange - we see the correct loads ....

ree

tgnutzmanntgnutzmann
tgnutzmann

Load data changes depending on filter for powder

Since it's happened a few times, I'd like to ask you guys a question.


When looking up data for 6.5 CM, I get for the 120 gr Hornady ELD Match bullet and Vihtavuori N130 the following:


Start = 32.4 gr / Max = 34.4 gr


so far so good. Now if I chose to filter the list by powder manufacturers, selecting Vihtavuori, now I get for N130


Start = 33.0 gr / Max = 34.6 gr


These differences aren't the world, but in shouldn't happen. Am I using the page incorrectly somehow?

Bugs
181 Views
Max
Max
Jun 23, 2025
•

Thanks for sharing. The differences are explained as follows:

  • we continously try to confirm our inputs (i.e. bullet length, sensible COL, case capacity, etc.)

  • this is also why we ask everyone to share and confirm such information

  • once data changes, we typically update our load data

  • however, sometimes the old data is still in the cache and shown first for better site speed

  • wenn you filter, the data gets recalculated and then deviates in such cases.


Hope this clarifies :-)

tsavocreektsavocreek
tsavocreek

Load Data Diary Panel Is Blank

When i click on a specific line of load data the "add to Diary" panel pops up but it is blank. nothing gets loaded to diary.

Bugs
197 Views
schwob2
schwob2
May 15, 2025
•

You mean this is empty when you click the line? Did you try another browser or device (mobile, etc) or did you try to delete browser history. It works fine for me at the moment. What browser /device are you using?


ree

    Members

    • gflungstrumgflungstrum
      gflungstrum
    • frankusmcbpdfrankusmcbpd
      frankusmcbpd
    • guhndawg
      guhndawg
    • SbaitsoSbaitso
      Sbaitso
    • Joe B. HTX
      Joe B. HTX
    See All Members (109)
    bottom of page