Load Specifications
Load data in caliber 7.82 Warbird with .308 | 166gr | Copper Bear bullet and 1 powder. The key underlying parameters are shown in the table above.
Important Notice: DO NOT go below Minimum Charge or above Maximum Charge. Since we have no control over the equipment and components used, any responsibility and liability for the results achieved is rejected.
Only powders/loads that match the current filter criteria are displayed: max pressure of a load ≤ 90% of max. standardized pressure, fill rate ≥ 80% and propellant combustion ≥ 95%. Use the sliders above the tables to adjust these thresholds.
Charge: Powder weight in grains. Start with the minimum load and work up carefully.
FR (Fill Rate): Case fill as a percentage. Values above 100% mean compressed loads.
MaxP / %: Maximum chamber pressure in bar and as a percentage of the standardized maximum for this caliber.
V(0): Muzzle velocity in feet per second (fps) at the standardized barrel length.
z (Powder Burn): Estimated propellant combustion percentage at bullet exit.
A valid access license is required to use the Personalized Load Calculator.
You can find more information in our FAQ: How can I use the Personalized Load Calculator?
Max Load - Barrel Length: 26"
| Powder | Charge | FR | MaxP | % | V(0) | z |
|---|---|---|---|---|---|---|
| Alliant Power Pro Varmint | <<locked>> | 88% | 60,263 psi | 90% | 3225 fps | 100% |
Start Load - Barrel Length: 26"
| Powder | Charge | FR | MaxP | % | V(0) | z |
|---|---|---|---|---|---|---|
| Alliant Power Pro Varmint | <<locked>> | 80% | 46,702 psi | 70% | 2986 fps | 98.8% |
This overview compares 1 powders for 7.82 Warbird loaded with the .308 | 166gr | Copper Bear . Alliant Power Pro Varmint delivers the highest muzzle velocity at 3,225 fps; across all powders the maximum-charge window runs from 3,225 fps to 3,225 fps. Alliant Power Pro Varmint gives the best case fill at 88 %, and 1 of the 1 powders fall inside the usable 80–100 % fill window.
Relative to the caliber's maximum pressure (460 MPa), the top charges use 90–90 %, leaving at least 10 % headroom. The 166.0 gr projectile in 0.308" calls for a 1:13.0 twist; slower twists will usually not stabilise this weight. Always begin at the start load and work up in small increments while checking case and primer for pressure signs.