Load data for 7.62 x 25 Tokarev + .308 | 55gr | Remington SP ACCELL SABOT

Recommended Powder(s): Accurate Solo 1000, Hodgdon TiteGroup, Rottweil P 801, SNPE Vectan BA10, Vihtavuori N310

Load Specifications

(Use the Personalized Load Calculator below to adjust )

Bullet:	.308 \| 55gr \| Remington SP ACCELL SABOT
Bullet Weight:	55gr \| 3.6g
Bullet Diameter:	0.308" \| 7.82mm
Bullet Length:	1.000" \| 25.4mm
Caliber:	7.62 x 25 Tokarev load data
Case Length (l3):	0.980" \| 24.9mm
Cartridge Length (C.O.L.):	1.369" \| 34.8mm
Seated Depth:	0.611" \| 15.5mm
Shank Seated Depth:	0.611" \| 15.5mm
Case Capacity:	16.8 Grains of Water \| 1.09 cm³
Primer Size:	Small Pistol (SP)
Max. allowed Pressure:	34809 psi \| 2400 bar
LID:	LID_B5161_C1116
Last updated:	2025-01-01

Load data for 74 loads in caliber 7.62 x 25 Tokarev with .308 | 55gr | Remington SP ACCELL SABOT bullet and 37 powders such as Accurate Solo 1000, Hodgdon TiteGroup, Rottweil P 801, SNPE Vectan BA10, Vihtavuori N310. The key underlying parameters are shown in the table above.

Important Notice: DO NOT go below Minimum Charge or above Maximum Charge unless there are reasons. Since xxlreloading.com has no control over the equipment and components used by the customer and the data used in connection with the website, any responsibility and liability for the results achieved is rejected. Also see our Terms of Service.

Questions regarding the load data: Please read the information in the next tab "Explanations".
A load must fulfill certain criteria to be listed in the default view below - see "powder criteria to fulfill to be listed".

Our load data might deviate from other sources - see the "most common reasons for deviations".

All loads are based on the bullet and case dimensions shown under "Load Specifications" - see "reloading suggestions" if you deviate.

You can set your specifications in the "Personalized Load Calculator".

Go to the bottom of the "Dashboard " page to set the measure system (imperial vs. metric)
No data yet
C.O.L. (Inch)
C.O.L. (mm)
We recommend you limit powder range to relevant brands to speed up re-calculation of results
Use the Personalized Load Calculator to customize loads to your own specific requirements. Find more details in the help section.

Our default view only displays powders/loads that fulfill certain criteria: Max pressure of a load <=90% of Max. Standardized Pressure. Fill Rate (Min FR): >80% and <100% for rife loads, >60% and <100% for pistol loads. Min. Propellant Combustion (Min z): >90% for rifle loads , >80% for pistol/revolver loads. Relax these criteria at your own risk to potentially get more powders shown in the load tables.
Case Length (Inch)
Case Length (mm)
CaseCapacity (GoW)
Min z (%)
Min FR (%)
Max FR*
Barrel Length (Inch)
Barrel Length (cm)
Safety Buffer (%)
.

Click on the desired row in the tables below to add a specific load / powder to your Diary and manage there.

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 70N	<<locked>>	93%	21567	62%	**71	94%
ADI APS 350	<<locked>>	92%	26165	75%	**43	100%
ADI APS 450	<<locked>>	97%	26948	77%	**99	100%
ADI AS 30	<<locked>>	92%	18782	54%	**27	100%
ADI AS 50N	<<locked>>	92%	19798	57%	**73	97%
Accurate Solo 1000 👍	<<locked>>	97%	23206	67%	**06	99%
[Accurate Solo 1250]*	<<locked>>	95%	15940	46%	**81	87%
[Alliant BULLSEYE]*	<<locked>>	95%	23235	67%	**75	88%
Baschieri & Pellagri 100	<<locked>>	95%	19203	55%	**37	95%
Hodgdon Clays	<<locked>>	92%	26150	75%	**63	100%
Hodgdon HP38	<<locked>>	83%	28108	81%	**30	98%
Hodgdon TiteGroup 👍	<<locked>>	77%	29878	86%	**24	100%
Hodgdon Universal	<<locked>>	93%	17013	49%	**57	91%
Lovex D032	<<locked>>	75%	30995	89%	**17	95%
Lovex S011	<<locked>>	93%	28572	82%	**98	97%
[Lovex S020]*	<<locked>>	95%	18420	53%	**66	85%
[Maxam CSB 1]*	<<locked>>	96%	14808	43%	**52	87%
[Maxam CSB 2]*	<<locked>>	93%	11400	33%	**38	89%
Maxam CSB 3	<<locked>>	93%	16737	48%	**11	94%
Maxam CSB 4	<<locked>>	95%	19551	56%	**73	98%
Maxam CSB 5	<<locked>>	93%	21814	63%	**99	100%
[Ramshot Silhouette]*	<<locked>>	94%	25150	72%	**94	84%
Ramshot Zip	<<locked>>	86%	30052	86%	**63	98%
ReloadSwiss RS 12	<<locked>>	94%	16491	47%	**12	98%
Rottweil P 801 👍	<<locked>>	94%	22017	63%	**94	100%
[SNPE Vectan BA 9]*	<<locked>>	95%	21045	60%	**70	89%
SNPE Vectan BA10 👍	<<locked>>	96%	30356	87%	**45	100%
[SNPE Vectan BA9 1/2]*	<<locked>>	93%	17419	50%	**24	89%
Shooters World Clean Shot	<<locked>>	75%	30995	89%	**17	95%
Shooters World Ultimate Pistol	<<locked>>	77%	29080	84%	**96	92%
[Somchem MS200]*	<<locked>>	96%	18115	52%	**34	83%
Somchem S121	<<locked>>	75%	29298	84%	**16	95%
Vihtavuori N310 👍	<<locked>>	92%	29791	86%	**94	100%
Vihtavuori N320	<<locked>>	97%	19058	55%	**99	98%
Vihtavuori N32C Tin Star	<<locked>>	95%	8253	24%	**8	95%
Vihtavuori N330	<<locked>>	97%	17042	49%	**60	91%
Winchester 231	<<locked>>	96%	30052	86%	**63	98%

Max Load - Barrel Length: 5.50''

Powder	Charge	FR	MaxP	%	V(0)	z
[ADI AP 70N]*	<<locked>>	66%	10182	29%	**30	81%
[ADI APS 350]²	<<locked>>	59%	11603	33%	**8	100%
ADI APS 450	<<locked>>	60%	11139	32%	**1	99%
ADI AS 30	<<locked>>	61%	8659	25%	**2	92%
[ADI AS 50N]*²	<<locked>>	59%	8499	24%	**2	84%
[Accurate Solo 1000]*	<<locked>>	63%	9979	29%	**2	88%
[Accurate Solo 1250]*	<<locked>>	84%	12227	35%	**66	82%
[Alliant BULLSEYE]*	<<locked>>	81%	16317	47%	**01	81%
[Baschieri & Pellagri 100]*	<<locked>>	63%	8035	23%	**3	80%
[Hodgdon Clays]²	<<locked>>	59%	11719	34%	**1	100%
[Hodgdon HP38]*	<<locked>>	60%	13663	39%	**06	88%
Hodgdon TiteGroup	<<locked>>	62%	18043	52%	**11	98%
[Hodgdon Universal]*	<<locked>>	74%	10182	29%	**30	81%
[Lovex D032]*	<<locked>>	60%	17680	51%	**68	87%
[Lovex S011]*	<<locked>>	60%	11197	32%	**1	83%
[Lovex S020]*	<<locked>>	86%	14127	41%	**52	80%
[Maxam CSB 1]*	<<locked>>	85%	11371	33%	**40	81%
[Maxam CSB 2]*	<<locked>>	78%	7702	22%	**1	80%
[Maxam CSB 3]*	<<locked>>	66%	8209	24%	**9	81%
[Maxam CSB 4]*	<<locked>>	61%	8209	24%	**6	85%
Maxam CSB 5	<<locked>>	64%	9950	29%	**1	97%
[Ramshot Silhouette]*	<<locked>>	87%	20189	58%	**89	80%
[Ramshot Zip]*	<<locked>>	60%	13010	37%	**86	86%
[ReloadSwiss RS 12]*	<<locked>>	66%	7165	21%	**5	84%
Rottweil P 801	<<locked>>	63%	8354	24%	**04	91%
[SNPE Vectan BA 9]*	<<locked>>	77%	13329	38%	**63	81%
SNPE Vectan BA10	<<locked>>	62%	13082	38%	**20	100%
[SNPE Vectan BA9 1/2]*	<<locked>>	78%	11922	34%	**60	82%
[Shooters World Clean Shot]*	<<locked>>	60%	17680	51%	**68	87%
[Shooters World Ultimate Pistol]*	<<locked>>	61%	16679	48%	**24	83%
[Somchem MS200]*	<<locked>>	92%	16244	47%	**81	81%
[Somchem S121]*	<<locked>>	60%	16302	47%	**43	87%
Vihtavuori N310	<<locked>>	60%	11240	32%	**40	100%
[Vihtavuori N320]*	<<locked>>	64%	7861	23%	**2	84%
[Vihtavuori N32C Tin Star]*	<<locked>>	69%	4699	14%	**8	83%
[Vihtavuori N330]*	<<locked>>	82%	11574	33%	**79	82%
[Winchester 231]*	<<locked>>	62%	11385	33%	**33	83%

Start Load - Barrel Length: 5.50''

Any powder missing? Then click here.

FR ... fill rate of the cartridge in percent

MaxP ... max. pressure of load in psi or bar

% ... max. pressure of load in percent of the maximum allowed pressure for this caliber

V(0) ... muzzle velocity in feet per second (fps) or meters per second (m/s)

z ... powder burnt in percent

[...] *... not dangerous but load has suboptimal powder burnt with possible characteristics such as extensive muzzle flash or inaccurate loads.

[...] ²... fill rate low - you might want to consider using a filler to ensure proper ignition.

[...] ᴾ... possible press load - work up slowly to this load while watching for signs of excessive pressure.

👍 ... recommended powder/load for this caliber and bullet combination based on its ballistic performance.

<<locked>>... you need to buy an access license to unlock the data