
Load Specifications
Load data in caliber .45-70 Govt. with .458 | 300gr | Winchester JHP 45-70 bullet and 5 powders. The key underlying parameters are shown in the table above. The recommended powders for this cartridge and bullet combination are Vihtavuori N120, ReloadSwiss RS 14 and Hodgdon TrailBoss.
Important Notice: DO NOT go below Minimum Charge or above Maximum Charge. Since we have no control over the equipment and components used, any responsibility and liability for the results achieved is rejected.
Only powders/loads that match the current filter criteria are displayed: max pressure of a load ≤ 90% of max. standardized pressure, fill rate ≥ 80% and propellant combustion ≥ 95%. Use the sliders above the tables to adjust these thresholds.
Charge: Powder weight in grains. Start with the minimum load and work up carefully.
FR (Fill Rate): Case fill as a percentage. Values above 100% mean compressed loads.
MaxP / %: Maximum chamber pressure in bar and as a percentage of the standardized maximum for this caliber.
V(0): Muzzle velocity in feet per second (fps) at the standardized barrel length.
z (Powder Burn): Estimated propellant combustion percentage at bullet exit.
A valid access license is required to use the Personalized Load Calculator.
You can find more information in our FAQ: How can I use the Personalized Load Calculator?
Max Load - Barrel Length: 24"
| Powder | Charge | FR | MaxP | % | V(0) | z |
|---|---|---|---|---|---|---|
| ADI AR 2207 | <<locked>> | 88% | 27,615 psi | 87% | 2001 fps | 95.9% |
| Hodgdon TrailBossᴾ | <<locked>> | 100% | 27,717 psi | 87% | 1345 fps | 100% |
| ReloadSwiss RS 14ᴾ | <<locked>> | 100% | 26,948 psi | 84% | 1375 fps | 100% |
| SNPE Vectan BA6 1/2 | <<locked>> | 82% | 27,833 psi | 87% | 1854 fps | 100% |
| Vihtavuori N120 | <<locked>> | 88% | 28,123 psi | 88% | 1985 fps | 97.3% |
Recommended = one of the top powders for this cartridge and bullet combination.
Start Load - Barrel Length: 24"
| Powder | Charge | FR | MaxP | % | V(0) | z |
|---|---|---|---|---|---|---|
| ADI AR 2207 | <<locked>> | 86% | 25,962 psi | 81% | 1962 fps | 95.1% |
| Hodgdon TrailBoss | 13.8 gr | 80% | 20,102 psi | 63% | 1201 fps | 100% |
| ReloadSwiss RS 14 | 14.1 gr | 80% | 19,682 psi | 62% | 1230 fps | 100% |
| SNPE Vectan BA6 1/2 | <<locked>> | 80% | 26,281 psi | 82% | 1821 fps | 100% |
| Vihtavuori N120 | 39.4 gr | 82% | 23,569 psi | 74% | 1870 fps | 95.1% |
Recommended = one of the top powders for this cartridge and bullet combination.
ᴾ possible press load - work up slowly to this load while watching for signs of excessive pressure.
This overview compares 5 powders for .45-70 Govt. loaded with the .458 | 300gr | Winchester JHP 45-70. ADI AR 2207 delivers the highest muzzle velocity at 2,001 fps; across all powders the maximum-charge window runs from 1,345 fps to 2,001 fps. Hodgdon TrailBoss gives the best case fill at 100 %, and 5 of the 5 powders fall inside the usable 80–100 % fill window.
Relative to the caliber's maximum pressure (220 MPa), the top charges use 84–88 %, leaving at least 12 % headroom. Hodgdon TrailBoss, ReloadSwiss RS 14 reach 100 % fill or more at maximum charge, so these are compressed loads: they need a long drop tube to seat cleanly and react sensitively to the case capacity of your own brass lot. Vihtavuori N120, ReloadSwiss RS 14, Hodgdon TrailBoss rank at the top here: for .45-70 Govt. with the .458 | 300gr | Winchester JHP 45-70 they combine a high case fill with complete burn and sit in the upper velocity band. Always begin at the start load and work up in small increments while checking case and primer for pressure signs.