Load data for .30 PICRA + .308 | 200gr | Nosler Partition SP

Recommended Powder(s):

Load Specifications

(Use the Personalized Load Calculator below to adjust )

Bullet:	.308 \| 200gr \| Nosler Partition SP
Manufacturer SKU:	35626
Bullet Weight:	200gr \| 13.0g
Bullet Diameter:	0.308" \| 7.82mm
Bullet Length:	<<locked>>
Caliber:	.30 PICRA load data
Case Length (l3):	1.291" \| 32.8mm
Cartridge Length (C.O.L.):	<<locked>>
Seated Depth:	<<locked>>
Shank Seated Depth:	<<locked>>
Case Capacity:	24.2 Grains of Water \| 1.57 cm³
Primer Size:	Small Pistol (SP)
Max. allowed Pressure:	40611 psi \| 2800 bar
LID:	LID_B4121_C311
Last updated:	2026-01-31

Load data for 44 loads in caliber .30 PICRA with .308 | 200gr | Nosler Partition SP bullet and 22 powder(s). The key underlying parameters are shown in the table above.

Important Notice: DO NOT go below Minimum Charge or above Maximum Charge unless there are reasons. Since xxlreloading.com has no control over the equipment and components used by the customer and the data used in connection with the website, any responsibility and liability for the results achieved is rejected. Also see our Terms of Service.

Questions regarding the load data: Please read the information in the next tab "Explanations".
A load must fulfill certain criteria to be listed in the default view below - see "powder criteria to fulfill to be listed".

Our load data might deviate from other sources - see the "most common reasons for deviations".

All loads are based on the bullet and case dimensions shown under "Load Specifications" - see "reloading suggestions" if you deviate.

You can set your specifications in the "Personalized Load Calculator".

Go to the bottom of the "Dashboard " page to set the measure system (imperial vs. metric)
No data yet
C.O.L. (Inch)
C.O.L. (mm)
We recommend you limit powder range to relevant brands to speed up re-calculation of results
Use the Personalized Load Calculator to customize loads to your own specific requirements. Find more details in the help section.

Our default view only displays powders/loads that fulfill certain criteria: Max pressure of a load <=90% of Max. Standardized Pressure. Fill Rate (Min FR): >80% and <100% for rife loads, >60% and <100% for pistol loads. Min. Propellant Combustion (Min z): >90% for rifle loads , >80% for pistol/revolver loads. Relax these criteria at your own risk to potentially get more powders shown in the load tables.
Case Length (Inch)
Case Length (mm)
CaseCapacity (GoW)
Min z (%)
Min FR (%)
Max FR*
Barrel Length (Inch)
Barrel Length (cm)
Safety Buffer (%)
.

Click on the desired row in the tables below to add a specific load / powder to your Diary and manage there.

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	74%	36506	90%	**40	100%
ADI APS 450	<<locked>>	62%	35273	87%	**7	100%
Accurate 4100	<<locked>>	74%	35636	88%	**25	94%
[Accurate No. 11 FS]*	<<locked>>	83%	36216	89%	**42	88%
Accurate TCM	<<locked>>	63%	35984	89%	**06	99%
Alliant 2400	<<locked>>	70%	35172	87%	**15	96%
Alliant BLUE DOT	<<locked>>	73%	36361	90%	**02	100%
Alliant Herco	<<locked>>	73%	36318	89%	**1	100%
Baschieri & Pellagri 102 Pistol	<<locked>>	74%	35012	86%	**9	100%
Hodgdon H110	<<locked>>	79%	36230	89%	**55	91%
Hodgdon LilGun	<<locked>>	79%	35549	88%	**84	97%
Maxam CSB 1	<<locked>>	64%	35505	87%	**9	100%
Ramshot Enforcer	<<locked>>	70%	35230	87%	**19	97%
ReloadSwiss RS 30	<<locked>>	95%	35505	87%	**75	94%
SNPE Vectan A0	<<locked>>	64%	36201	89%	**5	100%
SNPE Vectan BA6 1/2 👍	<<locked>>	97%	35839	88%	**29	99%
SNPE Vectan BA7 1/2	<<locked>>	67%	35389	87%	**8	100%
Somchem S265	<<locked>>	86%	36013	89%	**09	90%
Vihtavuori 3N38	<<locked>>	69%	35853	88%	**73	100%
Vihtavuori N105	<<locked>>	72%	35433	87%	**76	100%
Vihtavuori N110	<<locked>>	88%	36289	89%	**48	97%
[Winchester 296]*	<<locked>>	78%	35694	88%	**71	88%

Max Load - Barrel Length: 5.50''

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	61%	26165	64%	**5	100%
ADI APS 450	<<locked>>	60%	33605	83%	**3	100%
[Accurate 4100]*	<<locked>>	61%	23554	58%	**8	87%
[Accurate No. 11 FS]*	<<locked>>	72%	25063	62%	**8	81%
Accurate TCM	<<locked>>	61%	33649	83%	**76	98%
Alliant 2400	<<locked>>	61%	26223	65%	**4	92%
Alliant BLUE DOT	<<locked>>	61%	25875	64%	**1	97%
Alliant Herco	<<locked>>	61%	27050	67%	**3	100%
Baschieri & Pellagri 102 Pistol	<<locked>>	67%	29588	73%	**0	100%
[Hodgdon H110]*	<<locked>>	61%	20044	49%	**9	80%
[Hodgdon LilGun]*	<<locked>>	61%	18478	46%	**2	86%
Maxam CSB 1	<<locked>>	61%	32358	80%	**6	100%
Ramshot Enforcer	<<locked>>	61%	25599	63%	**4	93%
[ReloadSwiss RS 30]*	<<locked>>	72%	18579	46%	**9	80%
SNPE Vectan A0	<<locked>>	61%	32909	81%	**2	100%
[SNPE Vectan BA6 1/2]*	<<locked>>	68%	16447	40%	**7	87%
SNPE Vectan BA7 1/2	<<locked>>	61%	29907	74%	**5	100%
[Somchem S265]*	<<locked>>	67%	21553	53%	**6	80%
Vihtavuori 3N38	<<locked>>	61%	28195	69%	**1	100%
Vihtavuori N105	<<locked>>	61%	25106	62%	**5	100%
[Vihtavuori N110]*	<<locked>>	62%	16317	40%	**3	84%
[Winchester 296]*	<<locked>>	66%	23743	58%	**4	80%

Start Load - Barrel Length: 5.50''

Any powder missing? Then click here.

FR ... fill rate of the cartridge in percent

MaxP ... max. pressure of load in psi or bar

% ... max. pressure of load in percent of the maximum allowed pressure for this caliber

V(0) ... muzzle velocity in feet per second (fps) or meters per second (m/s)

z ... powder burnt in percent

[...] *... not dangerous but load has suboptimal powder burnt with possible characteristics such as extensive muzzle flash or inaccurate loads.

[...] ²... fill rate low - you might want to consider using a filler to ensure proper ignition.

[...] ᴾ... possible press load - work up slowly to this load while watching for signs of excessive pressure.

👍 ... recommended powder/load for this caliber and bullet combination based on its ballistic performance.

<<locked>>... you need to buy an access license to unlock the data