Load data for .30 PICRA + .308 | 175gr | Berger OTM

Recommended Powder(s):

Load Specifications

(Use the Personalized Load Calculator below to adjust )

Bullet:	.308 \| 175gr \| Berger OTM
Manufacturer SKU:	30105
Bullet Weight:	175gr \| 11.3g
Bullet Diameter:	0.308" \| 7.82mm
Bullet Length:	<<locked>>
Caliber:	.30 PICRA load data
Case Length (l3):	1.291" \| 32.8mm
Cartridge Length (C.O.L.):	<<locked>>
Seated Depth:	<<locked>>
Shank Seated Depth:	<<locked>>
Case Capacity:	24.2 Grains of Water \| 1.57 cm³
Primer Size:	Small Pistol (SP)
Max. allowed Pressure:	40611 psi \| 2800 bar
LID:	LID_B1083_C311
Last updated:	2026-01-21
Recommended Twist Rate:	1:11 - 1:9

Load data for 46 loads in caliber .30 PICRA with .308 | 175gr | Berger OTM bullet and 23 powder(s). The key underlying parameters are shown in the table above.

Important Notice: DO NOT go below Minimum Charge or above Maximum Charge unless there are reasons. Since xxlreloading.com has no control over the equipment and components used by the customer and the data used in connection with the website, any responsibility and liability for the results achieved is rejected. Also see our Terms of Service.

Questions regarding the load data: Please read the information in the next tab "Explanations".
A load must fulfill certain criteria to be listed in the default view below - see "powder criteria to fulfill to be listed".

Our load data might deviate from other sources - see the "most common reasons for deviations".

All loads are based on the bullet and case dimensions shown under "Load Specifications" - see "reloading suggestions" if you deviate.

You can set your specifications in the "Personalized Load Calculator".

Go to the bottom of the "Dashboard " page to set the measure system (imperial vs. metric)
No data yet
C.O.L. (Inch)
C.O.L. (mm)
We recommend you limit powder range to relevant brands to speed up re-calculation of results
Use the Personalized Load Calculator to customize loads to your own specific requirements. Find more details in the help section.

Our default view only displays powders/loads that fulfill certain criteria: Max pressure of a load <=90% of Max. Standardized Pressure. Fill Rate (Min FR): >80% and <100% for rife loads, >60% and <100% for pistol loads. Min. Propellant Combustion (Min z): >90% for rifle loads , >80% for pistol/revolver loads. Relax these criteria at your own risk to potentially get more powders shown in the load tables.
Case Length (Inch)
Case Length (mm)
CaseCapacity (GoW)
Min z (%)
Min FR (%)
Max FR*
Barrel Length (Inch)
Barrel Length (cm)
Safety Buffer (%)
.

Click on the desired row in the tables below to add a specific load / powder to your Diary and manage there.

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	72%	35621	88%	**45	100%
ADI APS 450	<<locked>>	64%	36289	89%	**8	100%
Accurate 4100	<<locked>>	73%	36303	89%	**43	93%
[Accurate No. 11 FS]*	<<locked>>	82%	36289	89%	**53	86%
Accurate No. 9	<<locked>>	63%	36390	90%	**30	98%
Accurate TCM	<<locked>>	62%	36260	89%	**17	98%
Alliant 2400	<<locked>>	70%	36289	89%	**40	96%
Alliant BLUE DOT	<<locked>>	72%	36318	89%	**17	100%
Baschieri & Pellagri 102 Pistol	<<locked>>	74%	35505	87%	**8	100%
Hodgdon H110	<<locked>>	77%	36013	89%	**66	90%
Hodgdon LilGun	<<locked>>	78%	35578	88%	**93	96%
Maxam CSB 1	<<locked>>	64%	35578	88%	**14	100%
Ramshot Enforcer	<<locked>>	69%	35563	88%	**37	96%
ReloadSwiss RS 30	<<locked>>	94%	36187	89%	**02	94%
SNPE Vectan A0	<<locked>>	63%	35418	87%	**47	100%
SNPE Vectan BA6 1/2	<<locked>>	95%	35955	89%	**43	98%
SNPE Vectan BA7 1/2	<<locked>>	67%	35926	88%	**06	100%
[Somchem S265]*	<<locked>>	85%	36289	89%	**24	89%
Vihtavuori 3N38	<<locked>>	69%	36303	89%	**88	100%
Vihtavuori N105	<<locked>>	72%	36042	89%	**98	100%
Vihtavuori N110	<<locked>>	87%	35969	89%	**60	96%
Vihtavuori N350	<<locked>>	63%	36318	89%	**15	100%
[Winchester 296]*	<<locked>>	77%	36390	90%	**93	87%

Max Load - Barrel Length: 5.50''

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	61%	26701	66%	**30	100%
ADI APS 450	<<locked>>	62%	34969	86%	**5	100%
[Accurate 4100]*	<<locked>>	61%	23873	59%	**53	86%
[Accurate No. 11 FS]*	<<locked>>	72%	26484	65%	**06	80%
Accurate No. 9	<<locked>>	61%	34214	84%	**04	97%
Accurate TCM	<<locked>>	61%	34084	84%	**94	98%
Alliant 2400	<<locked>>	61%	27557	68%	**19	92%
Alliant BLUE DOT	<<locked>>	61%	26107	64%	**70	97%
Baschieri & Pellagri 102 Pistol	<<locked>>	66%	29341	72%	**5	100%
[Hodgdon H110]*	<<locked>>	62%	21538	53%	**27	80%
[Hodgdon LilGun]*	<<locked>>	61%	19566	48%	**20	85%
Maxam CSB 1	<<locked>>	61%	32953	81%	**4	100%
Ramshot Enforcer	<<locked>>	61%	27122	67%	**19	93%
[ReloadSwiss RS 30]*	<<locked>>	72%	19682	48%	**04	80%
SNPE Vectan A0	<<locked>>	60%	32895	81%	**20	100%
[SNPE Vectan BA6 1/2]*	<<locked>>	68%	17303	43%	**2	87%
SNPE Vectan BA7 1/2	<<locked>>	62%	31082	77%	**53	100%
[Somchem S265]*	<<locked>>	69%	23293	57%	**20	81%
Vihtavuori 3N38	<<locked>>	61%	28776	71%	**89	100%
Vihtavuori N105	<<locked>>	61%	25889	64%	**70	100%
[Vihtavuori N110]*	<<locked>>	62%	17013	42%	**5	83%
Vihtavuori N350	<<locked>>	61%	33678	83%	**86	100%
[Winchester 296]*	<<locked>>	68%	26368	65%	**32	80%

Start Load - Barrel Length: 5.50''

Any powder missing? Then click here.

FR ... fill rate of the cartridge in percent

MaxP ... max. pressure of load in psi or bar

% ... max. pressure of load in percent of the maximum allowed pressure for this caliber

V(0) ... muzzle velocity in feet per second (fps) or meters per second (m/s)

z ... powder burnt in percent

[...] *... not dangerous but load has suboptimal powder burnt with possible characteristics such as extensive muzzle flash or inaccurate loads.

[...] ²... fill rate low - you might want to consider using a filler to ensure proper ignition.

[...] ᴾ... possible press load - work up slowly to this load while watching for signs of excessive pressure.

👍 ... recommended powder/load for this caliber and bullet combination based on its ballistic performance.

<<locked>>... you need to buy an access license to unlock the data