Load data for .30 PICRA + .308 | 165gr | Norma ORYX

Recommended Powder(s):

Load Specifications

(Use the Personalized Load Calculator below to adjust )

Bullet:	.308 \| 165gr \| Norma ORYX
Bullet Weight:	165gr \| 10.7g
Bullet Diameter:	0.308" \| 7.82mm
Bullet Length:	1.191" \| 30.3mm
Caliber:	.30 PICRA load data
Case Length (l3):	1.291" \| 32.8mm
Cartridge Length (C.O.L.):	2.172" \| 55.2mm
Seated Depth:	0.310" \| 7.9mm
Shank Seated Depth:	0.310" \| 7.9mm
Case Capacity:	24.2 Grains of Water \| 1.57 cm³
Primer Size:	Small Pistol (SP)
Max. allowed Pressure:	40611 psi \| 2800 bar
LID:	LID_B3864_C311
Last updated:	2026-01-21

Load data for 56 loads in caliber .30 PICRA with .308 | 165gr | Norma ORYX bullet and 28 powder(s). The key underlying parameters are shown in the table above.

Important Notice: DO NOT go below Minimum Charge or above Maximum Charge unless there are reasons. Since xxlreloading.com has no control over the equipment and components used by the customer and the data used in connection with the website, any responsibility and liability for the results achieved is rejected. Also see our Terms of Service.

Questions regarding the load data: Please read the information in the next tab "Explanations".
A load must fulfill certain criteria to be listed in the default view below - see "powder criteria to fulfill to be listed".

Our load data might deviate from other sources - see the "most common reasons for deviations".

All loads are based on the bullet and case dimensions shown under "Load Specifications" - see "reloading suggestions" if you deviate.

You can set your specifications in the "Personalized Load Calculator".

Go to the bottom of the "Dashboard " page to set the measure system (imperial vs. metric)
No data yet
C.O.L. (Inch)
C.O.L. (mm)
We recommend you limit powder range to relevant brands to speed up re-calculation of results
Use the Personalized Load Calculator to customize loads to your own specific requirements. Find more details in the help section.

Our default view only displays powders/loads that fulfill certain criteria: Max pressure of a load <=90% of Max. Standardized Pressure. Fill Rate (Min FR): >80% and <100% for rife loads, >60% and <100% for pistol loads. Min. Propellant Combustion (Min z): >90% for rifle loads , >80% for pistol/revolver loads. Relax these criteria at your own risk to potentially get more powders shown in the load tables.
Case Length (Inch)
Case Length (mm)
CaseCapacity (GoW)
Min z (%)
Min FR (%)
Max FR*
Barrel Length (Inch)
Barrel Length (cm)
Safety Buffer (%)
.

Click on the desired row in the tables below to add a specific load / powder to your Diary and manage there.

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	74%	36318	89%	**94	100%
ADI APS 350	<<locked>>	63%	36071	89%	**5	100%
ADI APS 450	<<locked>>	63%	35505	87%	**8	100%
Accurate 4100	<<locked>>	74%	35955	89%	**76	92%
[Accurate No. 11 FS]*	<<locked>>	83%	35766	88%	**86	85%
Accurate No. 9	<<locked>>	63%	36448	90%	**70	97%
Accurate Solo 1250	<<locked>>	62%	35969	89%	**56	100%
Accurate TCM	<<locked>>	63%	36201	89%	**60	98%
Alliant 2400	<<locked>>	71%	36347	90%	**83	95%
Alliant BLUE DOT	<<locked>>	74%	36332	89%	**53	99%
Baschieri & Pellagri 102 Pistol	<<locked>>	76%	36506	90%	**33	100%
[Hodgdon H110]*	<<locked>>	79%	36390	90%	**12	89%
Hodgdon LilGun	<<locked>>	80%	35882	88%	**29	95%
Lovex D037.2	<<locked>>	63%	36448	90%	**70	97%
Maxam CSB 1	<<locked>>	65%	35752	88%	**53	100%
Ramshot Enforcer	<<locked>>	71%	36506	90%	**86	96%
ReloadSwiss RS 30	<<locked>>	95%	35476	87%	**22	92%
SNPE Vectan A0	<<locked>>	64%	35346	87%	**83	100%
SNPE Vectan BA6 1/2	<<locked>>	96%	35404	87%	**73	97%
SNPE Vectan BA7 1/2	<<locked>>	68%	36535	90%	**52	100%
Shooters World Heavy Pistol	<<locked>>	63%	36448	90%	**70	97%
[Somchem S265]*	<<locked>>	86%	36071	89%	**57	88%
Vihtavuori 3N38	<<locked>>	69%	35708	88%	**17	100%
Vihtavuori N105	<<locked>>	73%	36448	90%	**43	100%
Vihtavuori N110	<<locked>>	88%	35650	88%	**93	95%
Vihtavuori N32C Tin Star	<<locked>>	78%	35244	87%	**1	100%
Vihtavuori N350	<<locked>>	64%	35781	88%	**48	100%
[Winchester 296]*	<<locked>>	78%	35650	88%	**16	85%

Max Load - Barrel Length: 5.50''

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	61%	25440	63%	**43	100%
ADI APS 350	<<locked>>	61%	34606	85%	**8	100%
ADI APS 450	<<locked>>	61%	34142	84%	**5	100%
[Accurate 4100]*	<<locked>>	61%	23235	57%	**70	84%
[Accurate No. 11 FS]*	<<locked>>	76%	28471	70%	**78	80%
Accurate No. 9	<<locked>>	61%	33330	82%	**27	96%
Accurate Solo 1250	<<locked>>	61%	34461	85%	**40	100%
Accurate TCM	<<locked>>	61%	33069	81%	**14	97%
Alliant 2400	<<locked>>	61%	26658	66%	**38	90%
Alliant BLUE DOT	<<locked>>	61%	25860	64%	**93	96%
Baschieri & Pellagri 102 Pistol	<<locked>>	64%	27325	67%	**8	100%
[Hodgdon H110]*	<<locked>>	65%	23134	57%	**93	80%
[Hodgdon LilGun]*	<<locked>>	61%	18753	46%	**30	83%
Lovex D037.2	<<locked>>	61%	34374	85%	**37	96%
Maxam CSB 1	<<locked>>	61%	32909	81%	**20	100%
Ramshot Enforcer	<<locked>>	61%	26208	65%	**35	91%
[ReloadSwiss RS 30]*	<<locked>>	76%	21350	53%	**66	80%
SNPE Vectan A0	<<locked>>	61%	32793	81%	**53	100%
[SNPE Vectan BA6 1/2]*	<<locked>>	67%	15809	39%	**9	83%
SNPE Vectan BA7 1/2	<<locked>>	61%	29834	73%	**76	100%
Shooters World Heavy Pistol	<<locked>>	61%	34374	85%	**37	96%
[Somchem S265]*	<<locked>>	72%	24642	61%	**76	80%
Vihtavuori 3N38	<<locked>>	61%	28166	69%	**19	99%
Vihtavuori N105	<<locked>>	60%	24468	60%	**83	100%
[Vihtavuori N110]*	<<locked>>	61%	16027	39%	**5	80%
Vihtavuori N32C Tin Star	<<locked>>	73%	31778	78%	**2	100%
Vihtavuori N350	<<locked>>	61%	33243	82%	**19	100%
[Winchester 296]*	<<locked>>	71%	28442	70%	**07	81%

Start Load - Barrel Length: 5.50''

Any powder missing? Then click here.

FR ... fill rate of the cartridge in percent

MaxP ... max. pressure of load in psi or bar

% ... max. pressure of load in percent of the maximum allowed pressure for this caliber

V(0) ... muzzle velocity in feet per second (fps) or meters per second (m/s)

z ... powder burnt in percent

[...] *... not dangerous but load has suboptimal powder burnt with possible characteristics such as extensive muzzle flash or inaccurate loads.

[...] ²... fill rate low - you might want to consider using a filler to ensure proper ignition.

[...] ᴾ... possible press load - work up slowly to this load while watching for signs of excessive pressure.

👍 ... recommended powder/load for this caliber and bullet combination based on its ballistic performance.

<<locked>>... you need to buy an access license to unlock the data