Load data for .30 PICRA + .308 | 150gr | Speer Spitzer Soft Point

Recommended Powder(s): none

Load Specifications

(Use the Personalized Load Calculator below to adjust )

Bullet:	.308 \| 150gr \| Speer Spitzer Soft Point
Manufacturer SKU:	2023
Bullet Weight:	150gr \| 9.7g
Bullet Diameter:	0.308" \| 7.82mm
Bullet Length:	1.030" \| 26.2mm
Caliber:	.30 PICRA load data
Case Length (l3):	1.291" \| 32.8mm
Cartridge Length (C.O.L.):	2.172" \| 55.2mm
Seated Depth:	0.149" \| 3.8mm
Shank Seated Depth:	0.149" \| 3.8mm
Case Capacity:	24.2 Grains of Water \| 1.57 cm³
Primer Size:	Small Pistol (SP)
Max. allowed Pressure:	40611 psi \| 2800 bar
LID:	LID_B6152_C311
Last updated:	2025-01-01

Load data for 42 loads in caliber .30 PICRA with .308 | 150gr | Speer Spitzer Soft Point bullet and 21 powders such as none. The key underlying parameters are shown in the table above.

Important Notice: DO NOT go below Minimum Charge or above Maximum Charge unless there are reasons. Since xxlreloading.com has no control over the equipment and components used by the customer and the data used in connection with the website, any responsibility and liability for the results achieved is rejected. Also see our Terms of Service.

Questions regarding the load data: Please read the information in the next tab "Explanations".
A load must fulfill certain criteria to be listed in the default view below - see "powder criteria to fulfill to be listed".

Our load data might deviate from other sources - see the "most common reasons for deviations".

All loads are based on the bullet and case dimensions shown under "Load Specifications" - see "reloading suggestions" if you deviate.

You can set your specifications in the "Personalized Load Calculator".

Go to the bottom of the "Dashboard " page to set the measure system (imperial vs. metric)
No data yet
C.O.L. (Inch)
C.O.L. (mm)
We recommend you limit powder range to relevant brands to speed up re-calculation of results
Use the Personalized Load Calculator to customize loads to your own specific requirements. Find more details in the help section.

Our default view only displays powders/loads that fulfill certain criteria: Max pressure of a load <=90% of Max. Standardized Pressure. Fill Rate (Min FR): >80% and <100% for rife loads, >60% and <100% for pistol loads. Min. Propellant Combustion (Min z): >90% for rifle loads , >80% for pistol/revolver loads. Relax these criteria at your own risk to potentially get more powders shown in the load tables.
Case Length (Inch)
Case Length (mm)
CaseCapacity (GoW)
Min z (%)
Min FR (%)
Max FR*
Barrel Length (Inch)
Barrel Length (cm)
Safety Buffer (%)
.

Click on the desired row in the tables below to add a specific load / powder to your Diary and manage there.

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	72%	36318	89%	**80	100%
Accurate 4100	<<locked>>	72%	35375	87%	**58	91%
[Accurate No. 11 FS]*	<<locked>>	81%	35650	88%	**75	84%
Alliant 2400	<<locked>>	69%	36129	89%	**68	94%
Alliant BLUE DOT	<<locked>>	71%	35201	87%	**25	99%
[Hodgdon H110]*	<<locked>>	76%	34766	86%	**62	87%
Hodgdon LilGun	<<locked>>	77%	35462	87%	**04	94%
Hodgdon TrailBoss	<<locked>>	93%	24308	60%	**2	100%
Maxam CSB 1	<<locked>>	63%	35418	87%	**29	100%
Ramshot Enforcer	<<locked>>	69%	35650	88%	**68	95%
ReloadSwiss RS 14	<<locked>>	93%	23844	59%	**2	100%
ReloadSwiss RS 30	<<locked>>	93%	35607	88%	**04	91%
SNPE Vectan A0	<<locked>>	63%	35868	88%	**78	100%
SNPE Vectan BA6 1/2	<<locked>>	95%	36361	90%	**65	97%
SNPE Vectan BA7 1/2	<<locked>>	65%	34563	85%	**17	100%
[Somchem S265]*	<<locked>>	83%	34954	86%	**22	86%
Vihtavuori 3N38	<<locked>>	67%	34925	86%	**93	100%
Vihtavuori N105	<<locked>>	71%	35549	88%	**16	100%
Vihtavuori N110	<<locked>>	85%	34403	85%	**62	94%
Vihtavuori N32C Tin Star	<<locked>>	77%	34925	86%	**33	100%
[Winchester 296]*	<<locked>>	76%	35375	87%	**94	84%

Max Load - Barrel Length: 5.50''

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	61%	26643	66%	**38	100%
[Accurate 4100]*	<<locked>>	61%	24772	61%	**65	84%
[Accurate No. 11 FS]*	<<locked>>	75%	29356	72%	**73	80%
[Alliant 2400]*	<<locked>>	61%	27586	68%	**17	89%
Alliant BLUE DOT	<<locked>>	61%	26832	66%	**88	96%
[Hodgdon H110]*	<<locked>>	66%	24787	61%	**91	80%
[Hodgdon LilGun]*	<<locked>>	61%	19870	49%	**12	82%
Hodgdon TrailBoss	<<locked>>	60%	13590	33%	**2	100%
Maxam CSB 1	<<locked>>	61%	33185	82%	**06	100%
Ramshot Enforcer	<<locked>>	61%	27325	67%	**20	90%
ReloadSwiss RS 14	<<locked>>	61%	13576	33%	**1	100%
[ReloadSwiss RS 30]*	<<locked>>	77%	22916	56%	**68	80%
SNPE Vectan A0	<<locked>>	61%	33678	83%	**48	100%
[SNPE Vectan BA6 1/2]*	<<locked>>	63%	15069	37%	**5	81%
SNPE Vectan BA7 1/2	<<locked>>	61%	30719	76%	**68	100%
[Somchem S265]*	<<locked>>	73%	26223	65%	**81	81%
Vihtavuori 3N38	<<locked>>	61%	29254	72%	**14	99%
Vihtavuori N105	<<locked>>	61%	25947	64%	**71	100%
[Vihtavuori N110]*	<<locked>>	63%	17724	44%	**37	81%
Vihtavuori N32C Tin Star	<<locked>>	61%	24932	61%	**2	100%
[Winchester 296]*	<<locked>>	71%	30356	75%	**02	80%

Start Load - Barrel Length: 5.50''

Any powder missing? Then click here.

FR ... fill rate of the cartridge in percent

MaxP ... max. pressure of load in psi or bar

% ... max. pressure of load in percent of the maximum allowed pressure for this caliber

V(0) ... muzzle velocity in feet per second (fps) or meters per second (m/s)

z ... powder burnt in percent

[...] *... not dangerous but load has suboptimal powder burnt with possible characteristics such as extensive muzzle flash or inaccurate loads.

[...] ²... fill rate low - you might want to consider using a filler to ensure proper ignition.

[...] ᴾ... possible press load - work up slowly to this load while watching for signs of excessive pressure.

👍 ... recommended powder/load for this caliber and bullet combination based on its ballistic performance.

<<locked>>... you need to buy an access license to unlock the data