Load data for .30 PICRA + .308 | 150gr | NorthFork Bonded Core

Recommended Powder(s): none

Load Specifications

(Use the Personalized Load Calculator below to adjust )

Bullet:	.308 \| 150gr \| NorthFork Bonded Core
Bullet Weight:	150gr \| 9.7g
Bullet Diameter:	0.308" \| 7.82mm
Bullet Length:	1.120" \| 28.4mm
Caliber:	.30 PICRA load data
Case Length (l3):	1.291" \| 32.8mm
Cartridge Length (C.O.L.):	2.172" \| 55.2mm
Seated Depth:	0.239" \| 6.1mm
Shank Seated Depth:	0.239" \| 6.1mm
Case Capacity:	24.2 Grains of Water \| 1.57 cm³
Primer Size:	Small Pistol (SP)
Max. allowed Pressure:	40611 psi \| 2800 bar
LID:	LID_B3916_C311
Last updated:	2025-01-01

Load data for 54 loads in caliber .30 PICRA with .308 | 150gr | NorthFork Bonded Core bullet and 27 powders such as none. The key underlying parameters are shown in the table above.

Important Notice: DO NOT go below Minimum Charge or above Maximum Charge unless there are reasons. Since xxlreloading.com has no control over the equipment and components used by the customer and the data used in connection with the website, any responsibility and liability for the results achieved is rejected. Also see our Terms of Service.

Questions regarding the load data: Please read the information in the next tab "Explanations".
A load must fulfill certain criteria to be listed in the default view below - see "powder criteria to fulfill to be listed".

Our load data might deviate from other sources - see the "most common reasons for deviations".

All loads are based on the bullet and case dimensions shown under "Load Specifications" - see "reloading suggestions" if you deviate.

You can set your specifications in the "Personalized Load Calculator".

Go to the bottom of the "Dashboard " page to set the measure system (imperial vs. metric)
No data yet
C.O.L. (Inch)
C.O.L. (mm)
We recommend you limit powder range to relevant brands to speed up re-calculation of results
Use the Personalized Load Calculator to customize loads to your own specific requirements. Find more details in the help section.

Our default view only displays powders/loads that fulfill certain criteria: Max pressure of a load <=90% of Max. Standardized Pressure. Fill Rate (Min FR): >80% and <100% for rife loads, >60% and <100% for pistol loads. Min. Propellant Combustion (Min z): >90% for rifle loads , >80% for pistol/revolver loads. Relax these criteria at your own risk to potentially get more powders shown in the load tables.
Case Length (Inch)
Case Length (mm)
CaseCapacity (GoW)
Min z (%)
Min FR (%)
Max FR*
Barrel Length (Inch)
Barrel Length (cm)
Safety Buffer (%)
.

Click on the desired row in the tables below to add a specific load / powder to your Diary and manage there.

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	74%	35781	88%	**63	100%
Accurate 4100	<<locked>>	74%	35462	87%	**48	91%
[Accurate No. 11 FS]*	<<locked>>	84%	36230	89%	**71	84%
Accurate No. 9	<<locked>>	64%	36492	90%	**45	96%
Accurate TCM	<<locked>>	64%	36477	90%	**39	97%
Alliant 2400	<<locked>>	72%	36376	90%	**55	93%
Alliant BLUE DOT	<<locked>>	74%	36201	89%	**29	98%
[Hodgdon H110]*	<<locked>>	80%	36550	90%	**81	87%
Hodgdon LilGun	<<locked>>	81%	36492	90%	**24	94%
Hodgdon TrailBoss	<<locked>>	96%	24700	61%	**5	100%
Lovex D037.2	<<locked>>	63%	35375	87%	**32	96%
Maxam CSB 1	<<locked>>	64%	35360	87%	**15	100%
Ramshot Enforcer	<<locked>>	71%	35041	86%	**45	94%
ReloadSwiss RS 14	<<locked>>	96%	24192	60%	**8	100%
ReloadSwiss RS 30	<<locked>>	95%	35375	87%	**94	90%
Rottweil P 806	<<locked>>	63%	36172	89%	**83	100%
SNPE Vectan A0	<<locked>>	63%	34751	86%	**48	100%
SNPE Vectan BA6 1/2	<<locked>>	96%	34577	85%	**39	96%
SNPE Vectan BA7 1/2	<<locked>>	68%	36158	89%	**27	100%
Shooters World Heavy Pistol	<<locked>>	63%	35375	87%	**32	96%
[Somchem S265]*	<<locked>>	87%	35969	89%	**25	86%
Vihtavuori 3N38	<<locked>>	70%	35636	88%	**02	100%
Vihtavuori N105	<<locked>>	74%	36201	89%	**19	100%
Vihtavuori N110	<<locked>>	89%	36042	89%	**78	94%
Vihtavuori N32C Tin Star	<<locked>>	78%	34867	86%	**24	100%
Vihtavuori N350	<<locked>>	63%	34679	85%	**07	100%
[Winchester 296]*	<<locked>>	78%	35012	86%	**78	83%

Max Load - Barrel Length: 5.50''

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	61%	25643	63%	**19	100%
[Accurate 4100]*	<<locked>>	61%	22843	56%	**25	82%
[Accurate No. 11 FS]*	<<locked>>	79%	30980	76%	**83	80%
Accurate No. 9	<<locked>>	61%	32619	80%	**83	94%
Accurate TCM	<<locked>>	61%	32590	80%	**76	95%
[Alliant 2400]*	<<locked>>	61%	25831	64%	**84	88%
Alliant BLUE DOT	<<locked>>	61%	25367	62%	**52	94%
[Hodgdon H110]*	<<locked>>	69%	25570	63%	**01	80%
[Hodgdon LilGun]*	<<locked>>	63%	19377	48%	**99	81%
Hodgdon TrailBoss	<<locked>>	60%	13213	33%	**5	100%
Lovex D037.2	<<locked>>	61%	33518	83%	**06	95%
Maxam CSB 1	<<locked>>	62%	32764	81%	**86	100%
[Ramshot Enforcer]*	<<locked>>	61%	25034	62%	**78	88%
ReloadSwiss RS 14	<<locked>>	62%	13184	32%	**5	100%
[ReloadSwiss RS 30]*	<<locked>>	82%	24308	60%	**84	81%
Rottweil P 806	<<locked>>	61%	34287	84%	**60	100%
SNPE Vectan A0	<<locked>>	61%	32401	80%	**22	100%
[SNPE Vectan BA6 1/2]*	<<locked>>	65%	15084	37%	**5	80%
SNPE Vectan BA7 1/2	<<locked>>	61%	29863	74%	**42	100%
Shooters World Heavy Pistol	<<locked>>	61%	33518	83%	**06	95%
[Somchem S265]*	<<locked>>	76%	26716	66%	**75	80%
Vihtavuori 3N38	<<locked>>	61%	27775	68%	**84	99%
Vihtavuori N105	<<locked>>	61%	24062	59%	**38	99%
[Vihtavuori N110]*	<<locked>>	65%	17782	44%	**33	81%
Vihtavuori N32C Tin Star	<<locked>>	61%	24424	60%	**6	100%
Vihtavuori N350	<<locked>>	61%	32256	79%	**81	100%
[Winchester 296]*	<<locked>>	75%	31531	78%	**32	81%

Start Load - Barrel Length: 5.50''

Any powder missing? Then click here.

FR ... fill rate of the cartridge in percent

MaxP ... max. pressure of load in psi or bar

% ... max. pressure of load in percent of the maximum allowed pressure for this caliber

V(0) ... muzzle velocity in feet per second (fps) or meters per second (m/s)

z ... powder burnt in percent

[...] *... not dangerous but load has suboptimal powder burnt with possible characteristics such as extensive muzzle flash or inaccurate loads.

[...] ²... fill rate low - you might want to consider using a filler to ensure proper ignition.

[...] ᴾ... possible press load - work up slowly to this load while watching for signs of excessive pressure.

👍 ... recommended powder/load for this caliber and bullet combination based on its ballistic performance.

<<locked>>... you need to buy an access license to unlock the data