Load data for .30 PICRA + .308 | 150gr | Ferrobull Tripple Expand Jagd

Recommended Powder(s): none

Load Specifications

(Use the Personalized Load Calculator below to adjust )

Bullet:	.308 \| 150gr \| Ferrobull Tripple Expand Jagd
Manufacturer SKU:	J-30-150B
Bullet Weight:	150gr \| 9.7g
Bullet Diameter:	0.308" \| 7.82mm
Bullet Length:	1.157" \| 29.4mm
Caliber:	.30 PICRA load data
Case Length (l3):	1.291" \| 32.8mm
Cartridge Length (C.O.L.):	2.172" \| 55.2mm
Seated Depth:	0.276" \| 7.0mm
Shank Seated Depth:	0.011" \| 0.3mm
Case Capacity:	24.2 Grains of Water \| 1.57 cm³
Primer Size:	Small Pistol (SP)
Max. allowed Pressure:	40611 psi \| 2800 bar
LID:	LID_B9067_C311
Last updated:	2025-01-01
Recommended Twist Rate:	1:12 - 1:10

Load data for 46 loads in caliber .30 PICRA with .308 | 150gr | Ferrobull Tripple Expand Jagd bullet and 23 powders such as none. The key underlying parameters are shown in the table above.

Important Notice: DO NOT go below Minimum Charge or above Maximum Charge unless there are reasons. Since xxlreloading.com has no control over the equipment and components used by the customer and the data used in connection with the website, any responsibility and liability for the results achieved is rejected. Also see our Terms of Service.

Questions regarding the load data: Please read the information in the next tab "Explanations".
A load must fulfill certain criteria to be listed in the default view below - see "powder criteria to fulfill to be listed".

Our load data might deviate from other sources - see the "most common reasons for deviations".

All loads are based on the bullet and case dimensions shown under "Load Specifications" - see "reloading suggestions" if you deviate.

You can set your specifications in the "Personalized Load Calculator".

Go to the bottom of the "Dashboard " page to set the measure system (imperial vs. metric)
No data yet
C.O.L. (Inch)
C.O.L. (mm)
We recommend you limit powder range to relevant brands to speed up re-calculation of results
Use the Personalized Load Calculator to customize loads to your own specific requirements. Find more details in the help section.

Our default view only displays powders/loads that fulfill certain criteria: Max pressure of a load <=90% of Max. Standardized Pressure. Fill Rate (Min FR): >80% and <100% for rife loads, >60% and <100% for pistol loads. Min. Propellant Combustion (Min z): >90% for rifle loads , >80% for pistol/revolver loads. Relax these criteria at your own risk to potentially get more powders shown in the load tables.
Case Length (Inch)
Case Length (mm)
CaseCapacity (GoW)
Min z (%)
Min FR (%)
Max FR*
Barrel Length (Inch)
Barrel Length (cm)
Safety Buffer (%)
.

Click on the desired row in the tables below to add a specific load / powder to your Diary and manage there.

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	72%	35882	88%	**80	100%
Accurate 4100	<<locked>>	73%	36506	90%	**71	91%
[Accurate No. 11 FS]*	<<locked>>	81%	34969	86%	**68	84%
Accurate TCM	<<locked>>	62%	36042	89%	**55	97%
Alliant 2400	<<locked>>	69%	35824	88%	**65	94%
Alliant BLUE DOT	<<locked>>	71%	35114	86%	**35	99%
[Hodgdon H110]*	<<locked>>	77%	35621	88%	**91	88%
Hodgdon LilGun	<<locked>>	78%	35679	88%	**17	94%
Hodgdon TrailBoss	<<locked>>	94%	24743	61%	**2	100%
Maxam CSB 1	<<locked>>	64%	36187	89%	**45	100%
Ramshot Enforcer	<<locked>>	70%	36318	89%	**88	95%
ReloadSwiss RS 14	<<locked>>	92%	23482	58%	**8	100%
ReloadSwiss RS 30	<<locked>>	94%	35824	88%	**14	91%
SNPE Vectan A0	<<locked>>	63%	35360	87%	**71	100%
SNPE Vectan BA6 1/2	<<locked>>	96%	36245	89%	**81	97%
SNPE Vectan BA7 1/2	<<locked>>	67%	36361	90%	**43	100%
[Somchem S265]*	<<locked>>	84%	34940	86%	**39	87%
Vihtavuori 3N38	<<locked>>	67%	34751	86%	**99	100%
Vihtavuori N105	<<locked>>	71%	35389	87%	**22	100%
Vihtavuori N110	<<locked>>	87%	36463	90%	**01	95%
Vihtavuori N32C Tin Star	<<locked>>	80%	36448	90%	**56	100%
Vihtavuori N350	<<locked>>	63%	36172	89%	**43	100%
[Winchester 296]*	<<locked>>	77%	35940	89%	**17	84%

Max Load - Barrel Length: 5.50''

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	61%	26368	65%	**45	100%
[Accurate 4100]*	<<locked>>	61%	24076	59%	**65	84%
[Accurate No. 11 FS]*	<<locked>>	76%	30153	74%	**83	80%
Accurate TCM	<<locked>>	61%	34156	84%	**25	97%
[Alliant 2400]*	<<locked>>	61%	27514	68%	**27	89%
Alliant BLUE DOT	<<locked>>	61%	26600	66%	**88	96%
[Hodgdon H110]*	<<locked>>	65%	24250	60%	**88	80%
[Hodgdon LilGun]*	<<locked>>	61%	19595	48%	**19	82%
Hodgdon TrailBoss	<<locked>>	61%	13750	34%	**5	100%
Maxam CSB 1	<<locked>>	62%	33765	83%	**19	100%
Ramshot Enforcer	<<locked>>	61%	26527	65%	**20	90%
ReloadSwiss RS 14	<<locked>>	60%	13097	32%	**1	100%
[ReloadSwiss RS 30]*	<<locked>>	78%	22887	56%	**68	81%
SNPE Vectan A0	<<locked>>	61%	33185	82%	**42	100%
[SNPE Vectan BA6 1/2]*	<<locked>>	63%	14953	37%	**5	81%
SNPE Vectan BA7 1/2	<<locked>>	61%	30356	75%	**68	100%
[Somchem S265]*	<<locked>>	73%	26252	65%	**84	81%
Vihtavuori 3N38	<<locked>>	61%	29008	71%	**17	99%
Vihtavuori N105	<<locked>>	61%	25585	63%	**81	100%
[Vihtavuori N110]*	<<locked>>	63%	17579	43%	**40	81%
Vihtavuori N32C Tin Star	<<locked>>	60%	24569	60%	**9	100%
Vihtavuori N350	<<locked>>	61%	34069	84%	**20	100%
[Winchester 296]*	<<locked>>	72%	31082	77%	**32	81%

Start Load - Barrel Length: 5.50''

Any powder missing? Then click here.

FR ... fill rate of the cartridge in percent

MaxP ... max. pressure of load in psi or bar

% ... max. pressure of load in percent of the maximum allowed pressure for this caliber

V(0) ... muzzle velocity in feet per second (fps) or meters per second (m/s)

z ... powder burnt in percent

[...] *... not dangerous but load has suboptimal powder burnt with possible characteristics such as extensive muzzle flash or inaccurate loads.

[...] ²... fill rate low - you might want to consider using a filler to ensure proper ignition.

[...] ᴾ... possible press load - work up slowly to this load while watching for signs of excessive pressure.

👍 ... recommended powder/load for this caliber and bullet combination based on its ballistic performance.

<<locked>>... you need to buy an access license to unlock the data