Load data for .260 PICRA + .264 | 97gr | IBEX TRD

Recommended Powder(s):

Load Specifications

(Use the Personalized Load Calculator below to adjust )

Bullet:	.264 \| 97gr \| IBEX TRD
Manufacturer SKU:	T9007
Bullet Weight:	97gr \| 6.3g
Bullet Diameter:	0.264" \| 6.71mm
Bullet Length:	1.102" \| 28.0mm
Caliber:	.260 PICRA load data
Case Length (l3):	1.515" \| 38.5mm
Cartridge Length (C.O.L.):	2.393" \| 60.8mm
Seated Depth:	0.224" \| 5.7mm
Shank Seated Depth:	0.122" \| 3.1mm
Case Capacity:	38.6 Grains of Water \| 2.51 cm³
Primer Size:	Large Pistol (LP)
Max. allowed Pressure:	56565 psi \| 3900 bar
LID:	LID_B7008_C251
Last updated:	2025-01-01
Recommended Twist Rate:	1:9 - 1:8

Load data for 64 loads in caliber .260 PICRA with .264 | 97gr | IBEX TRD bullet and 32 powder(s). The key underlying parameters are shown in the table above.

Important Notice: DO NOT go below Minimum Charge or above Maximum Charge unless there are reasons. Since xxlreloading.com has no control over the equipment and components used by the customer and the data used in connection with the website, any responsibility and liability for the results achieved is rejected. Also see our Terms of Service.

Questions regarding the load data: Please read the information in the next tab "Explanations".
A load must fulfill certain criteria to be listed in the default view below - see "powder criteria to fulfill to be listed".

Our load data might deviate from other sources - see the "most common reasons for deviations".

All loads are based on the bullet and case dimensions shown under "Load Specifications" - see "reloading suggestions" if you deviate.

You can set your specifications in the "Personalized Load Calculator".

Go to the bottom of the "My Account " page to set the measure system (imperial vs. metric)
No data yet
C.O.L. (Inch)
C.O.L. (mm)
Case Length (Inch)
Case Length (mm)
CaseCapacity (GoW)
Min z (%)
Min FR (%)
Max FR*
Barrel Length (Inch)
Barrel Length (cm)
Safety Buffer (%)
.
Use the Personalized Load Calculator to customize loads to your own specific requirements. Find more details in the help section.

Our default view only displays powders/loads that fulfill certain criteria: Max pressure of a load <=90% of Max. Standardized Pressure. Fill Rate (Min FR): >80% and <100% for rife loads, >60% and <100% for pistol loads. Min. Propellant Combustion (Min z): >90% for rifle loads , >80% for pistol/revolver loads. Relax these criteria at your own risk to potentially get more powders shown in the load tables.

Click on the desired row in the tables below to add a specific load / powder to your Diary and manage there.

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	69%	49951	88%	**70	100%
ADI APS 350	<<locked>>	75%	50604	89%	**90	101%
ADI APS 450	<<locked>>	74%	50154	89%	**96	100%
ADI AS 30	<<locked>>	70%	50647	90%	**26	100%
ADI AS 50N	<<locked>>	63%	50546	89%	**49	100%
Accurate 4100 👍	<<locked>>	63%	49385	87%	**72	99%
Accurate No. 11 FS	<<locked>>	70%	50169	89%	**98	95%
Accurate Solo 1000	<<locked>>	66%	49385	87%	**29	100%
Accurate Solo 1250	<<locked>>	64%	49806	88%	**49	100%
Alliant BLUE DOT	<<locked>>	66%	49588	88%	**49	100%
Baschieri & Pellagri 100	<<locked>>	64%	50227	89%	**19	100%
Hodgdon Clays	<<locked>>	73%	50386	89%	**93	100%
Hodgdon H110	<<locked>>	65%	50386	89%	**01	97%
Hodgdon LilGun	<<locked>>	64%	49763	88%	**81	100%
Hodgdon TrailBoss	<<locked>>	95%	31604	56%	**34	100%
Maxam CSB 1	<<locked>>	67%	50024	88%	**52	100%
Maxam CSB 2	<<locked>>	62%	49922	88%	**26	100%
Maxam CSB 3	<<locked>>	66%	50183	89%	**32	100%
Maxam CSB 4	<<locked>>	66%	50459	89%	**35	100%
Maxam CSB 5	<<locked>>	65%	49501	88%	**96	100%
ReloadSwiss RS 14	<<locked>>	97%	32764	58%	**70	100%
ReloadSwiss RS 30	<<locked>>	79%	50589	89%	**18	99%
SNPE Vectan A0	<<locked>>	65%	49995	88%	**81	100%
SNPE Vectan BA10	<<locked>>	68%	49414	87%	**86	100%
SNPE Vectan BA6 1/2 👍	<<locked>>	83%	50894	90%	**59	100%
SNPE Vectan BA7 1/2	<<locked>>	66%	50546	89%	**40	100%
Somchem S265	<<locked>>	75%	50024	88%	**81	97%
Vihtavuori 3N38	<<locked>>	63%	50589	89%	**22	100%
Vihtavuori N105	<<locked>>	64%	50241	89%	**09	100%
Vihtavuori N110 👍	<<locked>>	74%	50894	90%	**91	100%
Vihtavuori N32C Tin Star	<<locked>>	87%	50285	89%	**67	100%
Winchester 296	<<locked>>	64%	50386	89%	**34	95%

Max Load - Barrel Length: 5.50''

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	61%	40727	72%	**52	100%
ADI APS 350	<<locked>>	61%	38943	69%	**25	100%
ADI APS 450	<<locked>>	61%	39044	69%	**52	100%
ADI AS 30	<<locked>>	61%	42279	75%	**04	100%
ADI AS 50N	<<locked>>	61%	48834	86%	**26	100%
Accurate 4100	<<locked>>	61%	46514	82%	**26	98%
[Accurate No. 11 FS]*	<<locked>>	61%	37739	67%	**81	89%
Accurate Solo 1000	<<locked>>	61%	44237	78%	**60	100%
Accurate Solo 1250	<<locked>>	61%	46209	82%	**06	100%
Alliant BLUE DOT	<<locked>>	61%	43598	77%	**57	100%
Baschieri & Pellagri 100	<<locked>>	61%	46644	82%	**80	100%
Hodgdon Clays	<<locked>>	61%	40074	71%	**55	100%
Hodgdon H110	<<locked>>	61%	43613	77%	**86	95%
Hodgdon LilGun	<<locked>>	61%	45382	80%	**16	99%
Hodgdon TrailBoss	<<locked>>	61%	18347	32%	**8	100%
Maxam CSB 1	<<locked>>	61%	43439	77%	**70	100%
Maxam CSB 2	<<locked>>	61%	48312	85%	**19	100%
Maxam CSB 3	<<locked>>	61%	45165	80%	**76	100%
Maxam CSB 4	<<locked>>	61%	45252	80%	**60	100%
Maxam CSB 5	<<locked>>	61%	46137	82%	**57	100%
ReloadSwiss RS 14	<<locked>>	61%	18507	33%	**7	100%
ReloadSwiss RS 30	<<locked>>	61%	29791	53%	**57	91%
SNPE Vectan A0	<<locked>>	61%	44976	80%	**12	100%
SNPE Vectan BA10	<<locked>>	61%	42859	76%	**07	100%
SNPE Vectan BA6 1/2	<<locked>>	61%	28863	51%	**94	97%
SNPE Vectan BA7 1/2	<<locked>>	61%	44324	78%	**55	100%
Somchem S265	<<locked>>	61%	33431	59%	**06	90%
Vihtavuori 3N38	<<locked>>	61%	47413	84%	**77	100%
Vihtavuori N105	<<locked>>	61%	46905	83%	**70	100%
Vihtavuori N110	<<locked>>	61%	34925	62%	**29	97%
Vihtavuori N32C Tin Star	<<locked>>	61%	30966	55%	**04	100%
Winchester 296	<<locked>>	61%	46224	82%	**42	93%

Start Load - Barrel Length: 5.50''

Any powder missing? Then click here.

FR ... fill rate of the cartridge in percent

MaxP ... max. pressure of load in psi or bar

% ... max. pressure of load in percent of the maximum allowed pressure for this caliber

V(0) ... muzzle velocity in feet per second (fps) or meters per second (m/s)

z ... powder burnt in percent

[...] *... not dangerous but load has suboptimal powder burnt with possible characteristics such as extensive muzzle flash or inaccurate loads.

[...] ²... fill rate low - you might want to consider using a filler to ensure proper ignition.

[...] ᴾ... possible press load - work up slowly to this load while watching for signs of excessive pressure.

👍 ... recommended powder/load for this caliber and bullet combination based on its ballistic performance.