Load data for .260 PICRA + .264 | 140gr | RWS Doppelkern

Recommended Powder(s):

Load Specifications

(Use the Personalized Load Calculator below to adjust )

Bullet:	.264 \| 140gr \| RWS Doppelkern
Manufacturer SKU:	2311463
Bullet Weight:	140gr \| 9.1g
Bullet Diameter:	0.264" \| 6.71mm
Bullet Length:	1.140" \| 29.0mm
Caliber:	.260 PICRA load data
Case Length (l3):	1.515" \| 38.5mm
Cartridge Length (C.O.L.):	2.404" \| 61.1mm
Seated Depth:	0.251" \| 6.4mm
Shank Seated Depth:	0.251" \| 6.4mm
Case Capacity:	38.6 Grains of Water \| 2.51 cm³
Primer Size:	Large Pistol (LP)
Max. allowed Pressure:	56565 psi \| 3900 bar
LID:	LID_B5380_C251
Last updated:	2025-01-01

Load data for 44 loads in caliber .260 PICRA with .264 | 140gr | RWS Doppelkern bullet and 22 powder(s). The key underlying parameters are shown in the table above.

Important Notice: DO NOT go below Minimum Charge or above Maximum Charge unless there are reasons. Since xxlreloading.com has no control over the equipment and components used by the customer and the data used in connection with the website, any responsibility and liability for the results achieved is rejected. Also see our Terms of Service.

Questions regarding the load data: Please read the information in the next tab "Explanations".
A load must fulfill certain criteria to be listed in the default view below - see "powder criteria to fulfill to be listed".

Our load data might deviate from other sources - see the "most common reasons for deviations".

All loads are based on the bullet and case dimensions shown under "Load Specifications" - see "reloading suggestions" if you deviate.

You can set your specifications in the "Personalized Load Calculator".

Go to the bottom of the "Dashboard " page to set the measure system (imperial vs. metric)
No data yet
C.O.L. (Inch)
C.O.L. (mm)
We recommend you limit powder range to relevant brands to speed up re-calculation of results
Use the Personalized Load Calculator to customize loads to your own specific requirements. Find more details in the help section.

Our default view only displays powders/loads that fulfill certain criteria: Max pressure of a load <=90% of Max. Standardized Pressure. Fill Rate (Min FR): >80% and <100% for rife loads, >60% and <100% for pistol loads. Min. Propellant Combustion (Min z): >90% for rifle loads , >80% for pistol/revolver loads. Relax these criteria at your own risk to potentially get more powders shown in the load tables.
Case Length (Inch)
Case Length (mm)
CaseCapacity (GoW)
Min z (%)
Min FR (%)
Max FR*
Barrel Length (Inch)
Barrel Length (cm)
Safety Buffer (%)
.

Click on the desired row in the tables below to add a specific load / powder to your Diary and manage there.

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	66%	50212	89%	**91	100%
ADI APS 350	<<locked>>	73%	49705	88%	**34	101%
ADI APS 450	<<locked>>	72%	49676	88%	**43	100%
ADI AS 30	<<locked>>	68%	50183	89%	**60	100%
Accurate No. 11 FS 👍	<<locked>>	66%	49893	88%	**16	99%
Accurate Solo 1000	<<locked>>	64%	49400	87%	**57	100%
Accurate Solo 1250	<<locked>>	63%	50401	89%	**89	100%
Alliant BLUE DOT	<<locked>>	63%	50879	90%	**60	100%
Baschieri & Pellagri 100	<<locked>>	63%	50256	89%	**60	100%
Hodgdon Clays	<<locked>>	71%	49400	87%	**34	100%
Hodgdon TrailBoss	<<locked>>	95%	32227	57%	**27	100%
Maxam CSB 1	<<locked>>	66%	50560	89%	**83	100%
Maxam CSB 3	<<locked>>	65%	50473	89%	**76	100%
Maxam CSB 4	<<locked>>	64%	50299	89%	**73	100%
Maxam CSB 5	<<locked>>	65%	50618	89%	**53	100%
ReloadSwiss RS 14	<<locked>>	94%	32314	57%	**50	100%
ReloadSwiss RS 30 👍	<<locked>>	73%	49705	88%	**06	100%
SNPE Vectan BA10	<<locked>>	68%	50415	89%	**47	100%
SNPE Vectan BA6 1/2	<<locked>>	77%	49516	88%	**47	100%
Somchem S265 👍	<<locked>>	71%	49400	87%	**90	100%
Vihtavuori N110	<<locked>>	69%	49588	88%	**76	100%
Vihtavuori N32C Tin Star	<<locked>>	86%	49922	88%	**20	100%

Max Load - Barrel Length: 5.50''

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	61%	43584	77%	**22	100%
ADI APS 350	<<locked>>	61%	39465	70%	**15	100%
ADI APS 450	<<locked>>	61%	39900	71%	**29	100%
ADI AS 30	<<locked>>	61%	43076	76%	**81	100%
Accurate No. 11 FS	<<locked>>	61%	42656	75%	**11	97%
Accurate Solo 1000	<<locked>>	61%	45818	81%	**20	100%
Accurate Solo 1250	<<locked>>	61%	48428	86%	**70	100%
Alliant BLUE DOT	<<locked>>	61%	47587	84%	**14	100%
Baschieri & Pellagri 100	<<locked>>	61%	48559	86%	**43	100%
Hodgdon Clays	<<locked>>	61%	40683	72%	**32	100%
Hodgdon TrailBoss	<<locked>>	61%	18159	32%	**7	100%
Maxam CSB 1	<<locked>>	61%	45324	80%	**34	100%
Maxam CSB 3	<<locked>>	61%	46804	83%	**37	100%
Maxam CSB 4	<<locked>>	61%	46760	83%	**34	100%
Maxam CSB 5	<<locked>>	61%	47108	83%	**17	100%
ReloadSwiss RS 14	<<locked>>	61%	18362	32%	**7	100%
ReloadSwiss RS 30	<<locked>>	61%	34200	60%	**86	98%
SNPE Vectan BA10	<<locked>>	61%	43801	77%	**81	100%
SNPE Vectan BA6 1/2	<<locked>>	61%	31227	55%	**17	100%
Somchem S265	<<locked>>	61%	37376	66%	**29	97%
Vihtavuori N110	<<locked>>	61%	39102	69%	**35	100%
Vihtavuori N32C Tin Star	<<locked>>	61%	31299	55%	**07	100%

Start Load - Barrel Length: 5.50''

Any powder missing? Then click here.

FR ... fill rate of the cartridge in percent

MaxP ... max. pressure of load in psi or bar

% ... max. pressure of load in percent of the maximum allowed pressure for this caliber

V(0) ... muzzle velocity in feet per second (fps) or meters per second (m/s)

z ... powder burnt in percent

[...] *... not dangerous but load has suboptimal powder burnt with possible characteristics such as extensive muzzle flash or inaccurate loads.

[...] ²... fill rate low - you might want to consider using a filler to ensure proper ignition.

[...] ᴾ... possible press load - work up slowly to this load while watching for signs of excessive pressure.

👍 ... recommended powder/load for this caliber and bullet combination based on its ballistic performance.

<<locked>>... you need to buy an access license to unlock the data