XXL Discussion Group

I did it with 338-06 Not 9,3x62, and there is an important difference in the base diameter. look below. My process Anneal the brass

Dull length sizing with my 338-06 die. Measure ALL brass and trim if necessary In My case I could use the load I use for hunting for fire forming. As the difference between a 30-06 and 338-06 is only the bullet diameter. I do not know if its the same with 9,3. And done, that was all there was to it. HOWEVER. the base diameter of the 9,3 is 12,1mm while a 30-06 is 12mm. This might result in some very "blown" out cases that might work but wont look nice. I found this thread from USA, that might be helpfull. https://www.canadiangunnutz.com/forum/threads/forming-9-3x62-from-30-06-brass.663917/