This is a bad implemented section. In my 338 loads, the statement is that every inch of added barrel adds approx 7,8 fps. while the graph show bnetween 20 and 35 fps added. Maybe there is a conversion to m/s going or what do i know. And there is no option to shift the graph to fit some numbers from the load data table, Not really usable.
Go to Load Data by Bullet/Powder>Select Norma in Powder Section> See below powders, there is a graphic that shows "Norma Powders used by our Community..."> the legend for the powders listed shows Reload Swiss powders not Norma.
Since it's happened a few times, I'd like to ask you guys a question.
When looking up data for 6.5 CM, I get for the 120 gr Hornady ELD Match bullet and Vihtavuori N130 the following:
Start = 32.4 gr / Max = 34.4 gr
so far so good. Now if I chose to filter the list by powder manufacturers, selecting Vihtavuori, now I get for N130
Start = 33.0 gr / Max = 34.6 gr
These differences aren't the world, but in shouldn't happen. Am I using the page incorrectly somehow?
Thanks for sharing. The differences are explained as follows:
we continously try to confirm our inputs (i.e. bullet length, sensible COL, case capacity, etc.)
this is also why we ask everyone to share and confirm such information
once data changes, we typically update our load data
however, sometimes the old data is still in the cache and shown first for better site speed
wenn you filter, the data gets recalculated and then deviates in such cases.
Hope this clarifies :-)
When i click on a specific line of load data the "add to Diary" panel pops up but it is blank. nothing gets loaded to diary.
You mean this is empty when you click the line? Did you try another browser or device (mobile, etc) or did you try to delete browser history. It works fine for me at the moment. What browser /device are you using?
ok - we found and fixed the bug. Thanks for flagging it! Much appreciated!👍